Sports & Athletics

The Beginners Guide To Equipment (What You Need To Know To Get Started)

Tips for Using a Plasma Cutter Plasma cutting is a valuable tool for producing fast, tidy cuts in steel, aluminum, or stainless. This is possible through the use of plasma cutters that fuse a high-pressure air or gas flow with an electric arc. The heat can achieve a temperature of up to 40,000 degrees Fahrenheit. Below are some things to keep in mind while using a plasma cutter: Safety Above All While plasma cutting is not as intense as welding, you have to proceed as though it is. Ensure you wear flame-retardant clothes and hair protection. Put on glasses #5 eye protection and work in a safe spot. Be familiar with your surroundings. Keep in mind that the heat and light can be strong, and you have to ensure your safety.
What You Should Know About Sales This Year
Consumables
What You Should Know About Sales This Year
If you notice that your cuts have lost their sharpness, you may have to get new parts that make up the cutting head. Usually, this could consist of a heat shield, contact tip, insulators, nozzle, and offset tool. It’s smart to check the availability of these consumables when purchasing your plasma cutter. Select a current model with a convenient process for ordering parts. The Importance of Moisture Plasma cutters need clean, dry air in order to function properly. Moisture is the biggest cause of parts going bad. There are a few things you can do to stall the effects of moisture, and restrict it to a bare minimum. Give 25 – 30 feet of line going from the air compressor to the moisture trap. The moisture trap will work more efficiently if the air has an opportunity to cool first. You can get an air drier that utilizes silica gel to attract moisture from the air. Have two in fact – they are inexpensive. These may be installed at the compressor, as well as at the water trap to prolong the life of your consumables. The air driers themselves are going to be easier and cheaper to replace compared to the plasma cutter parts. Cutting Speed You have to cut at the correct speed. If you’re new to plasma cutting, it might take you a number of tries to dialed it in properly. Among the best signs is the direction of the sparks while you’re cutting. When you cut too fast, the sparks move towards you. Relax and slow it down. The sparks and dross have to head to the floor. The Angle Often, you would hold the plasma cutter at 90-degree angle to what you are cutting. Reaching the end of a cut, pull the angle up a bit to make for a beautifully smooth end of cut. Dross on the underside of your cut can be addressed with a small file.